Sticker Measures: 1.5" Wide x 2" Tall

To ensure your Sticker adheres correctly, follow these four simple steps.

1. Prep Your Surface and Pre-Squeegee Your Sticker

Prepping the Area - When necessary, clean the surface of your item before applying the Sticker using either soap & water or a mixture of rubbing alcohol and water (50/50 mix). The cleaner the surface, the longer it will endure natural elements, washing, and wear and tear. Although it will adhere without this, it is recommended.

Pre-Squeegee - Place the design face down with the white side facing up. Using a credit card or something similar, run over the whole design with medium pressure, back and forth 2-4 times. Additional pressure and repetitions should be applied on thin and separated design elements, such as small text.

2. Preparing your Sticker for Transfer

Gently peel the two sheets apart, watching to ensure the whole design lifts off onto the top carrier sheet.  NOTER: Don’t peel with your hands, peel with your EYES. Designs which contain thin lines and small separated elements, such as small text, the slower you should peel. If parts don't lift, re-squeegee from behind, and attempt to peel again from a different angle. You’ll get a feel for it with experience.

3. Placing Your Sticker Onto Your Item

First, identify the placement area on your item.

For smaller designs (4 inches & under), carefully place the design onto the placement area with two hands controlling the placement.

For larger designs (6 inches & larger), you may find it easier to place the sticker starting from one side and ending at the other. This will help control your placement, reduce bubbles underneath the design, and avoid wrinkling of the carrier sheet which could cause design elements being offset and/or design overlapping.Tip: Leave a corner of the carrier sheet unpressed to the product for easy peeling.

4. Completing the Transfer Process

After placing the design, firmly squeegee it 2-4 times. Peel slowly, watching to ensure all elements stick. Again, NOTE:  use your EYES and not just your hands. If any part of the design is not adhering, lay the carrier sheet back down, re-squeegee and try peeling from a different angle.